MAGTEK MCP DRIVER DOWNLOAD

The Magnetic Stripe application deals with decoding and presenting magnetic stripe card data. Your manual failed to upload The property type None is never returned. Page 43 Section 5. The Result Codes are the same as for Microprocessor cards. Once set, these property values will persist for the current connector until a device reset, or until they are changed by further property settings. Page 83 Section 9.

Uploader: Tygobei
Date Added: 8 May 2007
File Size: 39.6 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 78511
Price: Free* [*Free Regsitration Required]

Page Appendix B.

Page 51 Section 5. Page 87 Section 9.

Memory Card Support The bit address is added to the byte address to form the address of the first bit to be affected by the command. IntelliStripe Command Reference The following result codes magrek defined: You’ll get a reply from our team as soon as possible.

A generic command has a common meaning for different device applications.

Single card slot design simplifies user interface and removes the human-error element ensuring quality magstripe and smart card encoding. The existence of generic commands allows standardizing on commonly magrek commands across multiple device applications.

This will put the device in its power up state. However, this format is obsolete. This property contains the value of the communications protocol used by this device.

  MONACO DTP94 DRIVER

Your message has been sent. If it is available, the ATR from the card is returned. Quality by design Compact footprint, rugged design, and low audible noise, make it perfect for desktop card issuance.

Applicable documents, Standards, Magtek documents – MagTek INTELLISTRIPE 380 USB/RS-232 User Manual

If the notify read state is not set to OFF, then a notification message will be sent to the host when a card is read. Not all device applications support these commands.

Page 29 Section 4. This property magtk or disables MCP auto baud synchronization. The track of decoded data starts with a start sentinel and ends with an end sentinel and is converted to ASCII format.

The I has a full-featured command set that allows a customer’s software application to easily control and monitor status of all device operations. The reader will not ncp to consume a card if a card is already present in the transport.

MagTek IntelliCAT User Manual | Page 4 / 7

Changing these properties is not advisable unless the card you are operating is non-standard. Code Hex Meaning 00 Success, the command completed without problems 01 Failure, mmagtek command was not able to complete, see CondRpt property for details. Proprietary magstripe formats can be supported via a binary encode mode. The following describes each property this application supports. Page 81 Section 9.

  LOGITECH WEB CAMERA 8K89 LITE DRIVER

The specified address is a bit address.

Accessories, Related documents | MagTek SWIPE & PARK User Manual | Page 10 / 20

This command allows the application to select the connector to be used in commands that follow. This is the track that is sent in the notification message when a card is read. Or point us to the URL where the manual is located.

This application deals with host communications. Warning, the command completed, but some problems arose, see CondRpt property for details. The MCP protocol does not use this property unless its host communications applications MCP auto baud enable property is set to false.

This command can be used to modify the property default values so that the properties do not have to be initialized to other values after a power cycle or reset.